Tractors & Crawlers

Ford LT110 Specifications

Ford LT110 tractor specifications

Wheelbase42-1/2" (1079.5mm)
Width - Overall - Wide base tires31-3/4" (806mm)
Length - Overall57-3/4" (1467mm)
Height
To steering wheel37" (940mm)
To hood31-1/4" (794mm)
To backrest28-1/2" (728mm)
Ground clearance
To front axle7" (178mm)
To transmission5-1/2" (140mm)
To frame11" (279mm)
Turning radius32" (813mm)
3 speed transmission gear ratios
1st gear, total26.6:1
2nd gear, total13.6:1
3rd gear, total9.1:1
Reverse19.5:1
3 speed transmission m.p.h
(Ground speed at 3300 engine rpm)
1st gear1.84 mph (2.96 kph)
2nd gear3.45 mph (5.55 kph)
3rd gear5.50 mph (8.55 kph)
Reverse2.50 mph (4.02 kph)
Note: Above speeds will be lower under heavy load conditions.
Engine to transaxle reduction3.2:1
Tires
Front13X5.00-6; 2 ply tubeless, 13" dia. (330mm)
Rear18X9.50-8; 2,4 ply tubeless, 18" dia. (457mm)
StarterElectric start (B&S 191707) Flywheel magneto ignition - Includes 12 volt electric bendix drive starter and flywheel alternator, battery, starter switch, and wiring.
Engine
ModelBriggs & Stratton No. 252707
Horsepower11.0
Type4 cycle - Single cylinder, Air cooled
Oil capacity39 ounces (1.15 liters)
Fuel capacity1 gallon (3.78 liters)
Air cleanerPolyurethane
GovernorMechanical
Traction clutchV-belt idler clutch - Coupled with brake pedal. Clutch is automatically disengaged when the brake pedal is depressed. Mechanism for parking brake is provided.
BrakeRear wheels only. Caliper brake engages the transaxle pinion shaft.
SteeringGear-segment type, with 5.6:1 gear reduction.
HitchRear, fixed type for easy coupling of implements.
Lift handle6 positions; transport and 5 working positions.
Seat and fenderVinyl covered; cushioned on seat and backrest with foam rubber. Steel fenders are supplied as standard equipment. A seat safety switch system will stop the engine if the operator leaves the seat while the P.T.O. clutch lever is engaged.
Misc. informationThis tractor is referred to as either model 09JC3156 or 53156.

← Back to the Ford LT110 page